PlanetMinis Forums banner

level?

451 Views 8 Replies 5 Participants Last post by  Z50King
sano plus 2 swinger with elka shock and dampening rods in the front. .would that be level?



post up pics if you got em
1 - 9 of 9 Posts
yuo can always make it level by adjusting the fork height in the triple clamp
not if the rear is higher then the front and the clamps are slid all the way up on tubes.. im just concerned that the rear would be higher then the front
most aftermarket clamps allow you to lower the fork tubes about an extra inch, I would think that this would sit level but I am not 100% on that.
you could also just lower the back using the preload spring thing
stock length shock with remote resi
if its a stock length shock with a +2 swinger, and damping rods in forks



i would say it would sit perfect level
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top