PlanetMinis Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
156 Posts
Discussion Starter · #1 ·
I would like to run the Kx65 front wheel and hub\brake setup on my GPX forks for my KLX 110. Is it possible to make them work relitively easy? I see the Adapter for the CR85 caliper but would like to run the whole 65 setup.
 

· Registered
Joined
·
5,278 Posts
blackzrx said:
I would like to run the Kx65 front wheel and hub\brake setup on my GPX forks for my KLX 110. Is it possible to make them work relitively easy? I see the Adapter for the CR85 caliper but would like to run the whole 65 setup.


You would have to figure out other bearings that would except the bigger 15mm axle. The CR85 caliper works just as good if not better then the KX65 brake due to the fact that the rotor is a 220mm on the pitster LXR forks. And I would get the YZ250f/YZ450f Master cylinder not the KX65 cause the YZ stuff has such good feel in comparison.



Gary

STR
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top