PlanetMinis Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,542 Posts
Discussion Starter · #1 ·
I need to get a new set of brake pads for my bike and was thinking about doing a steel braided line while I was at it.



1 = What pads are best for road racing and where to get them?



2 = Who sells a stainless steel braided front brake line for the 65?
 

·
Registered
Joined
·
1,583 Posts
I did my brakes........ used the stock line.......... all new caliper froma Jap superbike....... and bigger rotor from an Xtreme CRII..... master cylinder from an Xtreme CRII



Its on an old thread someplace..........
 

·
Registered
Joined
·
208 Posts
Just upgraded my stock line to a stainless steel line. Decided to go with a 200mm brake rotor conversion kit from Walter over on the FLAMRA forum. He sold me the wheels and brake setup for less then it would have cost for a lot of peoples wheels. Very nice setup uses a stock caliper and master cylinder but uses a 200mm wave rotor and 12x2.15 rims. The stainless steel line was something I added on my own later on. As it is the bike brakes almost as well as my other 65 with a QTM/Brembo setup on it. Obviously its not going to be as good but hell I didn't pay over $500 for both wheels with the brakes setup so I am very pleased.
 
1 - 5 of 5 Posts
Top