[A25MX]

Anyone who has done this, how do you take them out?

 

[A25MX]

Anyone feel free to speak up.

 

[raisen727]

i just finished these u can heat up the outside of the leg alittle and they may slide out mine didnt so i had to stuff rags in and dremel the metal washer inside the seal and then it just poped out with a screwdriver.... just make sure u dont leave any shavings behind.

 

[DUANE290]

Slide Hammer

 

[A25MX]

i just finished these u can heat up the outside of the leg alittle and they may slide out mine didnt so i had to stuff rags in and dremel the metal washer inside the seal and then it just poped out with a screwdriver.... just make sure u dont leave any shavings behind.

I was thinking about doing that but I don't want to ruin the inside. How exactly did you do it cause I'd rather do it myself then bring it to the shop. Heating didn't work for me either.

 

[A25MX]

Slide Hammer

Where can I get one and how much are they? How do they work?

 

[raisen727]

i just slid the tube out so u can see the whole oil seal in the leg then i just carefully dremeled it i would go alittle then stop and try to pry it out with a screw driver