PlanetMinis Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter · #1 ·
How much work would it be to put a KTM 65 front end on my klx 110. What size bearings do I need? Do i need a new swingarm? Any help would be great.

Thanks

Wyatt
 

·
Registered
Joined
·
72 Posts
Discussion Starter · #8 ·
infidel said:
the 65sx forks are a little soft imo. so you definatily need springs too. the bar risers are a little low its worth the change to get the tsr conversion clamps pax sells them as well as a few other places online. and i did the cartridge upgrade to made them more adjustable. if i would have known then what i knew now i would went with regular zokes and got the kx65 wheel to go on it. i ended up ditching all the ktm and zoke front ends and use the kx65 setup with the works kit. way better than my zokes ever were and more travel and better brakes
I weigh 120 lbs and am 5'9" so I don't really need the stiffness yet.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top