PlanetMinis Forums banner
1 - 17 of 17 Posts

·
Registered
Joined
·
787 Posts
It's easier than doing a big bore kit.

You will have a grin from ear to ear after you ride with one.
 

·
Registered
Joined
·
227 Posts
The inner rotor kits are very easy to install. They are adjustable though. I have the Kitaco one and I set my magnetic pickup in the middle. It seems to run just fine, but I am sure I am going to try different settings to see the difference. I have an Xtreme, so it requires some cutting to put it on, but on an XR50 it is a direct bolt in.
 

·
Registered
Joined
·
6,382 Posts
ardfarkl said:
I was just given some pointers over the phone and was able to do it myself. I SUCK at mechanic work, so it can't be that hard at all.
it aint that hard to do just take ur time and lay out all the parts befor u begin and if u have any probs just put up a urgant post someone will be able to help u out on here :wink:
 

·
Registered
Joined
·
227 Posts
honestly, I think it revs a little quicker than a small two stroke. It hits hard too.
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top