hone it. as long as there are no gouges in it that you can feel with your fingernails, it will clean up and be usable with a hone.
Is this bad?
I bought a used 88cc kit off of a board member as useable ,and i want some opinions on weather this cylinder is useable or can be honed and used. I got a good deal on it but if i have to have it bored over and buy a piston kit the deal dos not seem so good at all. I put the pictures up at the link below so you can see them nice and big. Also can i use two nuts to remove one of the cylinder studs so i can drill my oil oriface?
http://smg.photobucket.com/albums/v293/brawnyrebel/bikes/
http://smg.photobucket.com/albums/v293/brawnyrebel/bikes/
1 - 1 of 17 Posts
1 - 1 of 17 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
PlanetMinis Forums
PlanetMinis forum is the internet's largest mini bike community. View thousands of photos, event coverage, tips, tricks and performance mods.
Full Forum Listing
