PlanetMinis Forums banner
1 - 17 of 17 Posts

· Registered
Joined
·
159 Posts
Discussion Starter · #1 ·
I bought a used 88cc kit off of a board member as useable ,and i want some opinions on weather this cylinder is useable or can be honed and used. I got a good deal on it but if i have to have it bored over and buy a piston kit the deal dos not seem so good at all. I put the pictures up at the link below so you can see them nice and big. Also can i use two nuts to remove one of the cylinder studs so i can drill my oil oriface?







http://smg.photobucket.com/albums/v293/brawnyrebel/bikes/
 

· Registered
Joined
·
159 Posts
Discussion Starter · #8 ·
Yeah. You would think you might mention that when you sell something. I was all excited to get it on but now i'm not sure it's worth the trouble of putting it on. I'm having it honed out this week and hopefully it will be alright. The 21 year old cylinder i took off the bike did not have a scratch in it.
 

· Registered
Joined
·
4,763 Posts
I'm not allowed to ride the 88 because local laws have a max. displacement of 50cc. So even though a cop would never know unless I told them or they knew about minibikes, my dad says it's wrong. But what bad comes from it. The motor run the stock gearing so it doesn't go faster, just gets to the same top speed in less time.
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top