How to bore your Cylinder..?

606 Views 3 Replies 4 Participants Last post by slowracer, Dec 23, 2008

SHADE

Discussion Starter · Dec 23, 2008

well i have a lathe machine and milling machine.. and im looking bore my stock cylinder. before atempting was woundering what info and help/ tools peoples used..ect... Re sleeving .. HELPPP me lol

thanks Seth

Save

1 - 4 of 4 Posts

vetmxer

· #2 · Dec 23, 2008

chances are you dont have a tool big enough and to buy one would not be cheap. if you do then use a fresh insert and start small and bump it up a little at a time. do you have a bore guage that big?

Save

Mxrider346

· #3 · Dec 23, 2008

PM Sent Eric at SPM Racing is all you need to know

Save

slowracer

· #4 · Dec 23, 2008

SHADE said:
well i have a lathe machine and milling machine.. and im looking bore my stock cylinder. before atempting was woundering what info and help/ tools peoples used..ect... Re sleeving .. HELPPP me lol

thanks Seth

Q&E in Anaslime.91fwy and glassel.

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month