PlanetMinis Forums banner

hondatrailbikes manual clutch questions?????

776 views 6 replies 3 participants last post by  Jetster220 
Not sure about the springs and plates but you shouldnt need them, it should be fine as is. As for installing, very simple, just pay attention to how the stocker comes out and it goes in basically the same. If you have any problems were here to help.
 
Strange, mine only came with one of those springs. But anyways one of those springs goes inside part 1 and then part 2 goes ontop of that and it should slid in and out and spring back. Those will go onto the outside of the clutch basket so that when you actuate the clutch it pushes it toward the crank and allowing it to work properly. Hope that helps some.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top