PlanetMinis Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
201 Posts
Discussion Starter · #1 ·
just recived my manual clutch kit and i have a few questions



1 will my uprated auto cluch springs and plates fit and is it worth swapping them over?



2 anyone know of a fitting guide before i start to try to figure it out for myself



thanks



paul
 

·
Registered
Joined
·
201 Posts
Discussion Starter · #4 ·
right i think i have most of it in correctly but there are a few bits im not sure about!!!!



do part 1 & 2 go together with one of the springs? (5) if so where does the other spring go?



i have now worked out where part 4 goes (the original was still in place :oops: )



i have put a seal in the hole for the kick starter so where does the other one go (3) as it is smaller



someone help please :? :?



 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top