PlanetMinis Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
997 Posts
Discussion Starter · #1 ·
This is a true Honda XR100 Motard from Japan

Many upgraded parts:
  • Yoshimura 115cc power up kit
  • Yoshimura carb
  • Braking front disk rotor
  • Leo Vince carbon exhaust
  • Takegawa kickstarter
  • G-Craft chain guard
  • K-street sliders
  • Takegawa rear under-fender

Bike has been in storage for past 5-6 years. Just got it out and gathered the extra parts I have too. Selling it all together.

I didn't ride on the streets, so that's why the headlight, taillight and other stuff isn't on the bike. I bought this bike from a guy in Texas who bought it without the original engine. He found a NSR100 engine and wire harness and put it in.

Extra parts:
  • new G-Craft +4" braced swingers (was about $600 or $800 new, if I remember right)
  • extra set of NSR50 wheel and tires, have new bearings and seals for them.
  • extra OEM Honda black plastics
  • OEM headlight and tail light - extra complete wire harness
  • OEM air box
  • 12" tire warmers

Bike is located in Cave Creek, AZ, which is north of Scottsdale. Can ship at buyers expense and arrangement.

Asking $5200
[email protected]
C: 815-414-2029

Tire Wheel Fuel tank Automotive fuel system Vehicle brake

Tire Wheel Fuel tank Automotive tire Automotive lighting

Tire Land vehicle Wheel Automotive lighting Motorcycle

Tire Wheel Automotive tire Tread Bicycle part

Luggage and bags Bag Personal protective equipment Eyewear Goggles
 

·
Registered
Joined
·
1,209 Posts
This is awesome! I looked at bringing one of these or an Ape back when I was in Japan a few years ago. That brings my question as to why I ended up not doing it, does it have paperwork to actually use it on the street here?
 

·
Registered
Joined
·
359 Posts
Same questions as Skywalker regarding paperwork! This is pretty sweet. I was lucky enough to get a Honda Ape 3 years ago! Good to see this forum isn't completely dead and taken over by Facebook groups.
 
1 - 4 of 4 Posts
Top