PlanetMinis Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello everyone, I am welding my own Nsr50 frame from scratch and I was wondering if anyone with an nsr50 could help me out and measure a couple things for me. I need the width of the of the frame like the red line in the picture I have attached, width and height of the rectangular tube used to make main part of frame, diameter of tubing used to support the seat, and inner diameter and outer diameter and length of the tube used for mouting the tripple tree. Also if anyone knows about wall thickness on any of the tubes please let me know! I am going to use 1/16 tubing.

274971
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top