PlanetMinis Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
i need to know the jetting for a takagawa 106 +R with a mikuni 26mm carb,

seems to be running lean and cuts out at low revs or is this something else?

let me know:)
 

·
Registered
Joined
·
141 Posts
rb65 said:
i need to know the jetting for a takagawa 106 +R with a mikuni 26mm carb,

seems to be running lean and cuts out at low revs or is this something else?

let me know:)


use some duct tape to cover your air filter a bit and see if that helps. it can tell you which way you need to go with it jetting wise too.
 

·
Registered
Joined
·
1,132 Posts
rb65 said:
i need to know the jetting for a takagawa 106 +R with a mikuni 26mm carb,

seems to be running lean and cuts out at low revs or is this something else?

let me know:)


is it cutting out at low end or has it got gnarly bog? Can you hold the throttle wide open and have it rev out?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top