PlanetMinis Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
Im looking to rig up a handbrake on my dirt fiddie for my homie to learn to stunt, i know ryan has the cable for $30 + shipping which is a bit steep to me, what length cable would i need with tall bars?
 

· Registered
Joined
·
13 Posts
I'm not sure, I've been looking at doing the same thing. Kit's online I've seen seem to be really overpriced, I used to ride a lot of BMX so I was planning on using a BMX brake cable because they can be shortened if necessary.

Doesn't quite answer the question, but I hope it helps
 

· Registered
Joined
·
1,804 Posts
I used a bmx cable and its ok
 

· Registered
Joined
·
64 Posts
I also was planning to use an odyssey linear bmx cable. I always mod bmx levers to fit too and have used bmx cables/levers for the clutch for years.

Since this is only a secondary brake option and you can only pull so hard with a matched lever i doubt it'd ever snap. if so trim it or buy new for $10.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top