PlanetMinis Forums banner
1 - 18 of 18 Posts

·
Registered
Joined
·
1,557 Posts
Would that billet plug work with the carb that comes with Vince's 86?
 

·
Registered
Joined
·
2,341 Posts
yea, i got a bigger one when i had a stock carb, its only like 5 bucks or somethin and its way worth it, haha if you want to use your same filter ive seen those forced intakes on ebay haha i wonder if those really help or whateve
 

·
Registered
Joined
·
4,430 Posts
Discussion Starter · #11 ·
get this, i used a eraser on the end on a pencil that was around when i pulled it apart. dont worry, i had to literally smash the sucker in there, its not going to move. ghetto fab u l ous :lol:
 

·
Registered
Joined
·
4,430 Posts
Discussion Starter · #15 ·
my setup now.

Removed choke, plugged with eraser.

62 main.

takegawa filter(the same as any aftermarket filter or modified filter would act)

clip ALL the way in the LOWEST position.

modified stock exaust.

i also have a 72kit but than wont matter.

it rips, way better flow than stock.

THE MORE THE BETTER, ANY ENGINE>
 

·
Registered
Joined
·
462 Posts
1. Take off carb.

2. If im not mistaken, there's 2 screws on a bar in there, take them out.

3. Grab choke assembly.

4. PULL.

5. It should now be out.

6. BE GHETTO AND CRAM AN ERASER IN THERE!!! :lol:
 

·
Registered
Joined
·
462 Posts
1. Take off carb.

2. If im not mistaken, there's 2 screws on a bar in there, take them out.

3. Grab choke assembly.

4. PULL.

5. It should now be out.

6. BE GHETTO AND CRAM AN ERASER IN THERE!!! :lol:
 
1 - 18 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top