PlanetMinis Forums banner
1 - 7 of 7 Posts

· Registered
Joined
·
135 Posts
Do you not have enough clearance to fit the 28? Or do you need the boot that fits on the carb? Or do you need to like twist the intake to fit the 28?
I’ll see what I have out In my garage
pretty sure ive got afew spares you can have I have one of those rings you bolt up to the motor and you can angle your intake to the side so the carb clears the Frame I had to run one of those on my 110
 

· Registered
Joined
·
30 Posts
Discussion Starter · #7 ·
Need to twist intake pretty much in between the 2 factory intake mounting holes added a big header now it either burns a hole In the filter or top of carb hits fuel petcock it I could split the 2 would be perfect when I ran my factory yx 140 I bought the slotted intake from pirahna which allowed you to clock the carb like 30 degrees let me no if you have something I’ll buy it would love to run that beast
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top