Joined
·
305 Posts
I'm selling my 50, I just put a valve rebuild kit in it along with new rings.. I'm looking to get no less than $2000 for it. This bike is worth a lot and the motor is super fresh, new cylinder and piston, rings, valve rebuild kit. The chain and sprockets are about finished.. I can purchase new and put them on before I ship it. Fully modded and you will not be dissapointed!! I'm located in Evans City, PA which is about 40 miles north of Pittsburgh. Buyer pays for shipping!
Chassis:
Red Baron Bars
Red Baron Forks w/ Complete Disk/Hub/12'' Wheel set-up
Red Baron Aluminum Pro Frame/Swingarm
Pro Wheel Rear wheel w/ HD spokes
PCS Sprockets w/ Renthal chain (all will need replaced soon)
Skinko Front Tire/ Michelin Rear
Engine:
TB 108 Crank/Race Head (New one)/ Cylinder -----> All replaced
Takegawa 3 spd Close Ratio Clutch
Kitaco Inner Rotor
Kiehin 24mm Carb
Two Bros Pipe
Other:
BBR Skid Plate
Red Baron Grey Plastic
Red Rear fender
BigMinis Factory Graphics
One Inustries complete seat
Two Bros Footpeg Mount
Fastway footpegs
Pictures:
![]()
![]()
![]()
Chassis:
Red Baron Bars
Red Baron Forks w/ Complete Disk/Hub/12'' Wheel set-up
Red Baron Aluminum Pro Frame/Swingarm
Pro Wheel Rear wheel w/ HD spokes
PCS Sprockets w/ Renthal chain (all will need replaced soon)
Skinko Front Tire/ Michelin Rear
Engine:
TB 108 Crank/Race Head (New one)/ Cylinder -----> All replaced
Takegawa 3 spd Close Ratio Clutch
Kitaco Inner Rotor
Kiehin 24mm Carb
Two Bros Pipe
Other:
BBR Skid Plate
Red Baron Grey Plastic
Red Rear fender
BigMinis Factory Graphics
One Inustries complete seat
Two Bros Footpeg Mount
Fastway footpegs
Pictures:
