PlanetMinis Forums banner

front number plate

617 Views 4 Replies 3 Participants Last post by  rlm996
I was wondering if a crf70 number plate would fit on my crf50 with a DNM front end or maybe even a klx number plate? I want something other than the flat square from a 50 haha
1 - 5 of 5 Posts
I put a KLX110 plate on the front of my daughters crf50 based china bike. I think it looks good.



See less See more
biggyb12 said:
I was wondering if a crf70 number plate would fit on my crf50 with a DNM front end or maybe even a klx number plate? I want something other than the flat square from a 50 haha


I had a 70 plate on my 50 worked fine.
ok thanks guys i didn't know if the bolt hole was so far off so that it wouldn't work now i just need to find a cheap one
I ended up drilling a hole in the front fender and using a small bolt to hold the bottom mounting tab of the number plate in place.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top