PlanetMinis Forums banner
1 - 16 of 16 Posts

·
Registered
Joined
·
1,169 Posts
Discussion Starter · #1 ·
I'm not getting any spark. I got the pig tales hooked up right,my ignition,kill switch, I think the problem is the coil. take a look at this. First off is the wire with the white stripe ground or not and how do these wires go into coil, and green wire gets grounded right. Ive tried a few ways but still no spark. A couple ways let out a spark. Please give me you subjection thanks

 

·
Registered
Joined
·
5,974 Posts
the black booted one that has the green wire hanging from it...unplug that green wire and put that boot on coil...then the green wire plugs into one of the plugs that the stock bump start plugged into on the wiring harness and then the other end gets grounded to the frame or a bolt on the motor
 

·
Registered
Joined
·
1,169 Posts
Discussion Starter · #12 ·
I don't no sh*t about this. never once have I fuc*ed with electrical. I got confused cause you sent it to me with that green wire pluged into the boot. But its fixed thanks
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top