PlanetMinis Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
4,430 Posts
Discussion Starter · #3 ·
the intake valve is almost exactly 1" across

exaust valve is about 7/8"

thats from the ridge to ridge, like what size it would need to seal.

but i dont know the exact specs.

the intake port is 7/8"

the exaust port is just shy of 7/8" too.

theres LOTS of steel that can get cut away to make a MASSIVE port job.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top