PlanetMinis Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
545 Posts
Discussion Starter · #1 ·
I thought I read something about this on here before, but I couldn't find anything from searching. So as the title says, does anybody have any info on how hard it is to setup a drz/klx110 stock swingarm on a fiddy? Also, how long is it? Would it be better than a pw80 (just comparing because the pw is a cheap +2" upgrade)? Thanks.
 

· Registered
Joined
·
1,482 Posts
if u go with the pw80 i think you have to run a special shock
 

· Registered
Joined
·
5,050 Posts
I'm running the PW swingarm, and for what i payed it works well. Whether or not the 110 swingarm fits on your bike depends on the axle diameter, and the distance between the bushings. The distance between the bushings on the PW swingarm is too narrow and requires a little modding. By the way, you have to run a "cambone" shock with the PW swingarm. They are always on ebay starting at 69 bucks.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top