PlanetMinis Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
501 Posts
Discussion Starter #1
Finally got out and put some serious time on our gen 3 non linkage roller over spring break. After 2 days the compression knob on the shock is cracked. It apears that it just barely hits the front bottom of the rear fender. Has any one else run across this problem? Does any one know if it possible to get another knob?

The loop that holds the front brake hose by the upper part of the fork leg has cracked also, any one know were I can get one of those? Is it brad specific or is there some place general I can look for one?

Had a real great time on the bike these last two days, it has been awesome riding it someplace other than the yard. Still doing a lot of setting up like getting back brake pedal adjusted to the righ hight ect. playing with compression and rebound clickers ect ect. It goes on an on!
 

·
Registered
Joined
·
501 Posts
Discussion Starter #3
Good old Gorilla glue fixed the brake hose holder.

Need info on the compression knob..........
 

·
Registered
Joined
·
328 Posts
we will be sifting through all our misc leftover gen #3 parts in a week or so...



please email me (through yahoo) exactly what it all is and I will call you about replacing it.



some stuff I can replace for free...



some stuff I can just cost out...



we will do our best for you....



bob
 
1 - 4 of 4 Posts
Top