PlanetMinis Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
509 Posts
Discussion Starter · #1 ·
when stacking the clutch plates i noticed on some pics and mine when i took it out the top friction plate is staggered which seems to be useless any help or suggestions. what would happen if you just stack all 5 the same ? and im installing new plates and tried to stagger the last one it didnt want to fit it was kinda tight. by the way its still auto does it make a difference once i go manual ? thanks
 

·
Registered
Joined
·
3,659 Posts
The staggered plate is in there to reduce unwanted frequencies in the clutch pack. In other words so it doesn't chatter.



It doesn't matter if you run an auto or manual clutch release.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top