PlanetMinis Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
Okay so I just bought a chp motor off here a month ago. I set everything up and it started after a few kicks . It seems that the bikes running lean . It'll start but it doesn't want to stay running ! It currently has a 130 main and a 51 pilot. The needle was one up from the bottom and I ran the clip two notches higher it diddnt seem to any bit.i live in newenglnd where were at sea level . The motor rips when it's wide open but as soon as ur off the gas of dies. Any help would be appreciated. This website has helped me out a ton now that I have a mini!!
 

·
Registered
Joined
·
8,247 Posts
does the idle jump back and forth ? or does it just slow down and die ? could be an air leak
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top