PlanetMinis Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
1,341 Posts
Discussion Starter · #1 ·
I NEED a picture of how you guys have run your skid plates with a CAT 5...i have a sano plate and its going onto a 124SE....and pics of how you got it to fit?
 

·
Registered
Joined
·
985 Posts
you have to take the pipe off first to put it on then slid it in, but be sure not to put the 2 side bolts on the cylinder so you can get the pipe back in. Be sure to loosen the motor mounts so you can slide the plate under it'll be much easier.
 

·
Registered
Joined
·
1,341 Posts
Discussion Starter · #7 ·
a pic would be helpful...thanks
 

·
Registered
Joined
·
1,341 Posts
Discussion Starter · #9 ·
yeah you do....can you whip my ass tomorrow too?
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top