PlanetMinis Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
287 Posts
Discussion Starter · #1 ·
Ok here's the deal. I attempted to fit my stock throttle cable into a Motion Pro full size throttle housing. Well i pulled too hard on the cable and now it 's stuck up in the carb cap... I need to remove the cable from the cap WITHOUT damaging anything. Thanks :)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top