PlanetMinis Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2,462 Posts
Discussion Starter · #1 ·
I have a 165 scut with a tbr head and a mikuni 26mm carb. It bogs on the low end but every now and then it won't. The carb is clean and no matter what I do to the mixture screw it won't change. I figure it's jetting so I was wondering if anyone had any input on what jets I should be running or if anyone has any suggestions. Thanks
 

·
Registered
Joined
·
3,659 Posts
You'll have to take the carb apart and find out what jets you have in there.

Main and pilot, also needle possition would be helpful too.



Post your findings and we can help you.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top