PlanetMinis Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
A friend found a 47 mm piston in China, being a machinist, i'd like to bore my stock jug out for the piston.



my question is: what size should the jug be for the 47mm piston, and what tolerance should i hold it to?



Thanks

Smacky
 

·
Registered
Joined
·
3 Posts
Discussion Starter #2
scratch that, i just pulled it apart and this is going to be more work then it's worth.



looking for a 72 jug now



thanks

smacky
 

·
Registered
Joined
·
4,287 Posts
Im almost positive i have one laying around, as a take off, = not used, 25 bucks+ shipping its yours, im at my buddies house but once i go home, ill PM you a message and let you know.



Where are you located?
 

·
Registered
Joined
·
3 Posts
Discussion Starter #4
50rider340 said:
Im almost positive i have one laying around, as a take off, = not used, 25 bucks+ shipping its yours, im at my buddies house but once i go home, ill PM you a message and let you know.



Where are you located?


just bought one on ebay, shipped, for $19.95. Thank you, though.



Smacky
 
1 - 5 of 5 Posts
Top