PlanetMinis Forums banner
1 - 13 of 13 Posts

·
Registered
Joined
·
4,659 Posts
I don't do what BBR does, I install the seals with the inner tube OUT. I use a common socket (something like 28mm I think) and just tap it down with a rubber hammer. Do this for the seal and dust seal THEN slide in the fork leg.
 

·
Registered
Joined
·
3,659 Posts
arlindsay1992 said:
I don't do what BBR does, I install the seals with the inner tube OUT. I use a common socket (something like 28mm I think) and just tap it down with a rubber hammer. Do this for the seal and dust seal THEN slide in the fork leg.






That "is" what BBR does.
 

·
Registered
Joined
·
481 Posts
Discussion Starter · #4 ·
arlindsay1992 said:
I don't do what BBR does, I install the seals with the inner tube OUT. I use a common socket (something like 28mm I think) and just tap it down with a rubber hammer. Do this for the seal and dust seal THEN slide in the fork leg.


thanks, I will give this a shot. Ive heard of people using pvc pipes in the past.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top