PlanetMinis Forums banner
1 - 7 of 7 Posts

· Registered
Joined
·
618 Posts
Discussion Starter · #3 ·
fr5e0ak said:
i did when i had them, it doesnt last long, it will go away


Do you know what it is? I just can't figure it out. It sounds like washer on the bottom of the bushing is hitting the c-clip, but i'm not sure.
 

· Registered
Joined
·
4,543 Posts
its topping out hard because the springs are new. once they break in itll be nice. mine took FOREVER, but now with the 1+" cromo legs its almost not springy. make super sure you get your clips in there tight and seated in the groove. [tip; take a few q-tips and clean the grease out of the groove, and off of washer and clip. i blew out my bushings a couple of times and found that this keeps them in]
 

· Registered
Joined
·
405 Posts
oh, that's what that was. i thought that was just my fat ass! i put springs up front first, seem to remember hearing somethin, than a week later put my rear spring on and nothin more happened (went away or broke in, i don't know). what i do know is springs front and rear seem to work better the more they break in. or that could be in my mind.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top