PlanetMinis Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
306 Posts
I ground the welds for the brake stay tab plate off the 50 arm and did some grinding on it to get it to fit flush with the side plate of the 70 arm, then welded it in place.

A bolt/spacer works fine, but youll have to find a 2-3mm washer to take up the space that the 50 tab plate usually takes up
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top