damn i must be really hard on equipment
any one have problems breaking plates in the takegawa econo clutch???
last week my clutch messed up i pulled it apart and had broke all the teeth off of 2 of the plates no biggie i order new plates and put em in ride 1 time and the clutch was actin up so i just pulled it apart and wtf 2 of the plates are about to break again
note the takegawa clutch take 2 metals that are cut like a stock clutch plate w the groove cut in the middle the teeth on 2 of the plates
note the takegawa clutch take 2 metals that are cut like a stock clutch plate w the groove cut in the middle the teeth on 2 of the plates
1 - 3 of 3 Posts
this hasent happened to anyone???
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
PlanetMinis Forums
PlanetMinis forum is the internet's largest mini bike community. View thousands of photos, event coverage, tips, tricks and performance mods.
Full Forum Listing
