PlanetMinis Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi everyone. I'm new to this forum and wanted to see if anyone can help me with an ignition problem.

I have 1984 ATC70. I rebuilt the stator, new points and condenser, new ignition coil. The bike was running fine until the other day, I started it, it spit and sputtered and wouldn't start again.

It has no spark. The black ignition wire has continuity to ground even when the points are open. If I remove the ground from the exciter coil the continuity goes away when I open the points.

Does anyone know if the condenser could be my problem? Can it go bad and short to ground?

I appreciate any help. Thanks.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top