PlanetMinis Forums banner

82 ct 70 ogm 160 need lighting help

395 Views 2 Replies 2 Participants Last post by  huntmod
installed a ogm 160 into 82 ct 70 and have it up and running fine but have not connected either of the two yellow stator wires to anything. would like to get the lights working. ordered a 12/6/volt regulator and have looked at some examples of how to hook it up but have not had any luck. it does produce good ac voltage across the two yellow wires out of stator. I used the connector off the 70 stator as the connector for regulator ,then tied them in to the harness as illustrated in the examples found. it says to retain stock battery for 6v. I only get about two volts at battery. any suggestions thanks phillip
1 - 3 of 3 Posts
I looked at this print today. mine has two yellows coming off the lighting coil portion of the stator.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.