PlanetMinis Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Has anybody tried those off-branded kits you see on Amazon/eBay? Junk, half decent? Graphics line up perfectly?
 

·
Registered
Joined
·
3,974 Posts
I know someone who ordered the alpinestars set and the logo was upside down on the number plates. Also the plastic normally doesn't have much flex, and snaps very easily.
 

·
Registered
Joined
·
1,239 Posts
They're junk. Wanna make a bike look decent enough to sell it? Good enough. Aside from that, spend the money on good plastic.
 

·
Registered
Joined
·
10 Posts
if you put a nice set of graphics on them, they will snap. i got a black set and ride them blank. 25$ they are cheap but hold up enough. id rather have a nice set, but then again 25$ is to cheap. i got the kit where the number plates match the color of the bike.
 

·
Registered
Joined
·
3 Posts
I run an indoor mini supermoto series on my crf 50 and run the cheap amazon plastics. We go down quite often and run into each other. Have yet to snap anything yet. Only some crease marks where I can tell it has bent pretty far without breaking.
 

·
Registered
Joined
·
639 Posts
I run them without graphics bc they are not worth putting $$(graphics) on.
270893
 

·
Registered
Joined
·
13 Posts
1 - 7 of 7 Posts
Top