PlanetMinis Forums banner
1 - 1 of 1 Posts

· Registered
3,896 Posts
Discussion Starter · #1 ·
Selling a 2008 -2009 stock swinger. Bushings are pressed out, chain guide mounts shaved, and some additional welds to the chain guide mount and shock mount area. I was planning to send it out for powdercoat, and run a Pivot Works bearing kit- then use it on one of my stockers. I ended up selling the one, so I have no use for this swinger. (I had three of these swingers done, Two I'm using on my two stockers. The one build is doc'd on here). Comes with the Outlaw chain guide in pic. Chain guide is beat up, but it works. Located in Cleveland, OH $25 plus shipping. [email protected]
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.