PlanetMinis Forums banner
1 - 7 of 7 Posts

Registered
Joined
6 Posts
Discussion Starter · #5 ·
WOW , That seems a bit on the rich side.....Does the Clymer manual give the needle marking??
I've been studying pictures of the Honda needle set (part # 16012-957-003) and have been able to extrapolate three numbers "230" , there SHOULD be two or three other numbers and/or letters.
 

Registered
Joined
6 Posts
Discussion Starter · #7 ·
Hey much thanks for the input given!!!

After much scrutiny of pictures online and a little extra research and digging I've found the needle number to be J2302G , I have a small collection of needles and just so happen to have that needle!!!!
As for the clip position , groove #4 may be correct as long as some jackhole didnt change the needle jet on me!!!....Hopefully not otherwise I guess I'll be ordering the Honda set.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top