PlanetMinis Forums banner
1 - 11 of 11 Posts

·
Registered
Joined
·
408 Posts
Discussion Starter · #1 ·
things annoying me, is it bad? ive checked the valve clearance twice its fine just ticks like crazy, hoping it will go away when the valves seat better. Dont have the rubber dampners for the cylinder that was missing, but anyone else notice this is a loud motor? Also my shift forks just slipped out of my shift drum and wont go past 1st gear so its time to split the cases again.
 

·
Registered
Joined
·
408 Posts
Discussion Starter · #9 ·
i run .06 and .06mm and its tickingg, mite switch it up

I did the motor myself and did put in a billet countershaft (since ive broke 2 stock ones) and shift star blah blah no crank tho, wont be needed
 

·
Registered
Joined
·
8,629 Posts
you may think your setting it to .006 but your really at .010 or something.....



always re-check your clearance.



if its loud your probably not using the feelers properly....you should only hear a slight tick if anything at all.
 

·
Registered
Joined
·
1,808 Posts
the +r heads all tick thats why they come with the rubber dampners.I havent heard one that hasnt from 138 to 180 they all do if you run the r head.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top