PlanetMinis Forums banner

106 stroker oil cooler.

217 Views 1 Reply 2 Participants Last post by  dood
ok guys where my oil cooler is now right behind the front fender i dont think much air i going through the fins. Since only one type of oil cooler works for the takegawa 106 kit can i make longer lines so i can on the gas tank or behind my front number plate with a square cut out. I also want to do this because where it sits now its going to get muddy and lessen the point of the oil cooler even more. Thanks Brandon
1 - 2 of 2 Posts

adding longer lines will reduce your oil pressure. go to the 50 section under Takegawa dohc thread and read on.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.